Alpine KTX-100EQ Manual De Operación página 4

Connections
Before setting MultEQ, connect all other devices.
1
Install the CDA-9887/CDA-9887R into the vehicle.
2
After Installing the unit, make sure that sound is output from each speaker.
3
Press the OPEN button to open the front panel, then slide it in the left direction A, and
pull out towards you B to remove.
4
Connect the Head Unit Connection Cable, USB Cable and Microphone to the Interface
Box.
5
Connect the USB Cable to a USB port of your PC.
6
Connect the Head Unit Connection Cable to the connector of the CDA-9887/CDA-9887R
with the front panel removed.
• Be sure to connect the cable to the CDA-9887/CDA-9887R lastly. Failure to do so may result in communication
error and measurement may not be possible.
7
Check all connections, start the MultEQ setting.
2
-EN
USB Cable
Interface Box
CDA-9887/
CDA-9887R
Head Unit Connection Cable
Sound Characteristics Measurement Microphone