Alpine KTX-100EQ Manual De Operación página 8

10
When the selection of Target curve is complete, double-clicking the Send Filter
button to move to the setting of the CDA-9887/CDA-9887R. Select Curve Memory 1 or
Curve Memory 2 to store in the CDA-9887/CDA-9887R.
• You can store two curve settings for one measurement result.
11
If you are not satisfied with the measurement result, you can start from the procedure
in step 7 by double-clicking the Re-Measure button.
• If you perform the measurement again using the Re-Measure button, note that the previously stored settings in
the CDA-9887/CDA-9887R will be cleared and replaced by the new one.
12
When the memory setting is complete, click x on the right side of the screen and
double-clicking OK on the EXIT screen to close the IMPRINT SOUND MANAGER
program.
13
After you have finished the MultEQ setting, disconnect the head unit connection cable
from the CDA-9887/CDA-9887R, and then bring the front panel back to the original
position.
• When you bring the front panel back to the original position, do not turn power off and on with the ignition key
or battery.
14
Enjoy the CDA-9887/CDA-9887R by turning on the MultEQ mode.
For details on operation, refer to the Owner's Manual supplied with the CDA-9887/CDA-9887R.
About Trademark
• This device is manufactured under license from Audyssey Laboratories. U.S. and Foreign patents
pending. Audyssey MultEQ XT is trademark of Audyssey Laboratories.
• Microsoft and Windows are trademarks, or registered trademarks of Microsoft Corporation in the United
States and/or other countries.
6
-EN