Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step by step operating instructions for the LAMP RECEIVERS
A Quick Note before You Set Up the LAMP RECEIVERs:
WARNING: For indoor use only. If a LAMP RECEIVER is exposed to rain or moisture, immediately disconnect the LAMP RECEIVER from the
AC outlet to reduce the risk of electric shock or fire and consult authorized service personnel.
WARNING: Use only incandescent bulbs (up to 300 watts total) in lamps that are to be controlled by Lamp Receivers. Do not use
fluorescents, halogens or low voltage lighting systems. Using any other type bulbs could damage bulbs and/or Lamp Receivers. Attempting to
control any other device by the Lamp Receivers, could damage that device and may damage the Lamp Receiver, which could result in serious
personal injury and/or property damage.
CAUTION: Touch activated lamps should not be used with Lamp Receivers. Damage to lamp may occur.
CAUTION: Do not use the LAMP RECEIVER with a lamp that is connected to a timer or photo-sensor switch. Damage to timer or switch
could occur.
Step 1:
Set the HOUSE CODE to the same letter that you selected on the MESSENGER HUB, then plug the LAMP RECEIVER into the AC outlet
currently being used by the lamp you wish to control.
Step 2:
Select a UNIT CODE color to match the zone color that you laid out on the back of the INDOOR REMOTE. Now
you will need to assign a specific UNIT CODE for the LAMP RECEIVER. Within the color that you have picked you
have 3 number choices. In the example in Figure 8 the LAMP RECEIVER is set to Yellow 8.
Step 3:
Turn lamp on first, then plug into the receptacle on the underside of the LAMP RECEIVER.
Step 4:
Turn color dial on INDOOR REMOTE so that it matches the color setting on the LAMP RECEIVER. To turn the
lamp on and off, press the switch which corresponds with the number selected on the LAMP RECEIVER.
Figure 9 depicts activating LAMP RECEIVER set to Yellow 8.
NOTE: Lamps connected to LAMP RECEIVERS can still be controlled by the lamps switch. Remember
that lamp switch must be turned on in order for the lamp to be controlled by the Freewire system.
8
8
9
ON
OFF
ON
ON
ON
OFF
OFF
OFF
ON
ON
ON
MOOD 1
MOOD 2
HOUSE
OFF
OFF
OFF
Publicidad
Tabla de contenido
