5
Technical data
Min./max. temperature
Min./max.
operating
pressure
Condensate inlet
Condensate drain line
Hose nozzle
Max.
compressor capacity
Max. cold dryer capacity
Condensate
Weight
Mains power supply
Frequency
Max. power input
Protection class
1.
These specifications are valid for Europe, large parts of
Southeast Asia, North and South Africa and parts of
North and South America with a modest climate. For oth-
er areas, please contact the manufacturer.
See fig. 2a for dimensions.
6
Safety instructions
DANGER
Personal injury/property damage pos-
sible!
Do not use the condensate discharger in
potentially explosive atmospheres or ar-
eas exposed to freezing temperatures.
CAUTION
Damaged caused by incorrect thread!
The use of conical threaded connections is
not permitted.
WARNING
Damage to the connexion cable!
Protect it from sharp edges, oil and heat!
Grasp the plug and unplug it from the
power outlet!
+1/+60 °C
0.8/16 bar
G1/2
Inches
G1/4
Inches
8-10
mm
3
2.5
m
/min.
1
1
3
5.0
m
/min.
with/without
oil content
0.8
kg
230
V
50-60
Hz
<0.5
VA
IP 54
• Be calm and focused and ensure proper
operation.
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage,
financial
harm or risk of accident.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
• Only instructed personnel are authorised
to operate and perform maintenance tasks
on the condensate discharger.
• Before performing any maintenance or re-
pair work, disconnect the power supply
(pull the power plug) and depressurise the
condensate discharger, including the con-
densate inlet. A shut-off ball valve must be
installed in the supply line leading to the
condensate discharger!
• Keep personnel and animals away from the
operation area and prevent contact with
discharged condensate.
• Never exceed the maximum operating
pressure of 16 bar!
• Electrical work must always be carried out
by qualified electricians.
• Do not use the test button for permanent
drainage.
• Dispose of condensate in accordance with
the Water Resources Act (WRA) or the rel-
evant national regulations!
• Dispose of the device in accordance with
the valid statutory regulations.
• Prohibited: manipulation, inappropriate
use, temporary repairs, discharge of other
media, removal or use of damaged safety
equipment, operating a malfunctioning or
leaking system, use of non-original spare
parts, transporting, maintaining, repairing,
leaving a pressurised machine unattended,
smoking, naked flames, removing stickers.
D
Ecomat 3100
loss,
environmental
7