1byone 700US-0005 Manual De Instrucciones página 3

EN
DE
FR
ES
Note: After selecting the weight unit, put the scale on a
IT
hard, flat surface and use the procedures below to
start the measurement. The scale will automatically
shut off after 10 seconds of inactivity.
3-2. Measuring (Unit kg selected)
a) Please put the scale on a hard, flat surface.
b) Please stand on the scale to turn it on.
c) Stand still and the display will blink three times
presenting the confirmed weight measurement.
The scale will then turn off after 7 seconds.
Note: If you want to measure again, completely step off and
then step back on the scale.
4. Indication Message
4-1. Low battery indication: When "Lo" is shown on the
screen, the scale will turn off after a few seconds.
Please change the battery.
02
4-2. Err is shown when the scale is overloaded. Please
remove the weight from the scale to protect the
sensors.
5. Reminder
5-1. Do not place the scale on carpets or soft surfaces.
Only place on hard, flat surfaces.
5-2. The surface of the scale can be slippery if wet. Please
make sure both the glass surface and your feet are
dry before using.
5-3. This scale is not waterproof. Do not expose to mois-
ture.
5-4. Clean the scale with a slightly damp cloth. Do not use
any chemical/abrasive cleaning agents.
5-5. Please remove the battery if the scale is not be used
for an extended period of time.
5-6. When using the scale for the first time, or when
changing its location, it should be turned on twice
(on, off, then on again) and should be free of any
objects to ensure accurate measurements. Failure to
do this may result in incorrect measurements.
03
EN
DE
FR
ES
IT