How To Use - Hitachi DH 30PC2 Manual De Instrucciones

English
8. Selecting the driver bit
Screw heads or bits will be damaged should an inappropriate bit for the screw
diameter be employed to drive in the screws.
9. Selecting the function mode
You can switch functions to the 3 modes of "hammering only, "rotation +
hammering", and "rotation only" by turning the change lever while pressing
the push button. Set the
to be used.
CAUTION:
Before operating the change lever, check and make sure that the motor has
stopped.
A failure can occur if it is operated while the motor is running.
To operate the change lever, press the push button, and release the lock of the
change lever. Also, check and make sure after operation that the push button
has returned and that the change lever has been locked.
Switch the change lever without mistake. If it is used at a position halfway,
there is a fear that the service life of the switching mechanism may be shortened.

HOW TO USE

CAUTION:
To prevent accidents, make sure to turn the switch off and disconnect the plug
from the receptacle when the drill bits and other various parts are installed or
removed. The power switch should also be turned off during a work break and
after work.
1. Switch operation
The rotation speed of the drill bit can be controlled steplessly by varying the
amount that the trigger switch is pulled. Speed is low when the trigger switch is
pulled slightly and increases as the switch is pulled more.
2. Rotation + Hammering
This rotary hammer can be set to
rotation and hammering mode by
pressing the push button and turning
the change lever to
Turn the grip slightly and confirm that
the clutch has been engaged with a
click.
10
mark position of the change lever to that of the mode
mark. (Fig. 4)
Change lever
Fig. 4
Push
button