Packing List - EGO BC3800E Manual De Uso

PACKING LIST

EN
PART NAME
Brush Cutter
3-teeth blade with Sheath
Guard Assembly
Nut
Outer Flange
Hex Wrench
Multi-Function Wrench
Double-shoulder Strap
Operator's Manual
DESCRIPTION
KNOW YOUR BRUSH CUTTER (Fig. A)
1. Speed Limiting Lever
2. Lock-off Lever
3. Wing Bolt
4. Trigger
5. Bike Handle
6. Shaft
7. Cutting Line
8. Guard Assembly
9. Trimmer Head
10. Sealing Screw
11. Shaft-locking Hole
12. Guard Accessory
13. Multi-Function Wrench
14. Hex Wrench
15. 3-teeth Blade
16. Outer Flange
17. Nut
18. Release Button
19. Rubber Pad Protection
20. Latch
21. Electric Contactsms
22. Ejection Mechanism
23. Strap Buckle
24. Hip-pad
12
56 VOLT LITHIUM-ION REAR MOTOR BIKE-HANDLE BRUCHCUTTER — BC3800E
WARNING:
guard firmly in place. The guard must always be on the
QUANTITY
tool to protect the user.
1
WARNING:
1
trimmer head, the guard accessory with line–cutting
blade should be mounted onto the guard. Failure to
1
comply will result in overly long cutting line and overload
1 the motor. Never use the trimmer head without guard
accessory.
1
ASSEMBLY
1
1
WARNING:
not operate the brush cutter until the parts are replaced.
1
Use of the brush cutter with damaged or missing parts
1
could result in serious personal injury.
WARNING:
cutter or create accessories not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possibly serious personal injury.
WARNING:
installing or removing the guard and doing any
maintenance on the 3-teeth blade/line-cutting blade. Be
careful of the line-cutting blade on the guard accessory /
3-teeth blade for protecting your hands from being injured
by both the blades.
WARNING:
cause serious personal injury, always remove the battery
pack from the tool when assembling parts or transporting
the machine.
WARNING:
and bike handle firmly in place.
result in possible serious personal injury.
MOUNTING AND ADJUSTING THE BIKE HANDLE
The brush cutter is stored as shown in Fig. B. Firstly,
loosen the wing bolt on the connecting joint and then lift
the bike handle 180° around the shaft (Fig. C), turn it 90°
anticlockwise to make it face the bump head (Fig. D).
Lastly, move it back and forth to achieve a comfortable
working position and tighten the bolt.
NOTICE:
perpendicular to the shaft is only permitted.
Never operate the tool without the
When the tool is equipped with a
If any parts are damaged or missing, do
Do not attempt to modify the brush
Always wear heavy gloves when
To prevent accidental starting that could
Never operate the tool without the guard
Failure to comply could
Operating the machine with the bike handle