Troubleshooting - EGO BC3800E Manual De Uso

TROUBLESHOOTING

PROBLEM
Fail to start.
Stop working.
56 VOLT LITHIUM-ION REAR MOTOR BIKE-HANDLE BRUCHCUTTER — BC3800E
CAUSE SOLUTION
◾
The battery pack is not attached to the
brush cutter.
◾
No electrical contact between the brush
cutter and the battery pack.
◾
The battery pack is depleted.
◾
The lock-off lever and trigger are not
depressed simultaneously.
◾
The motor is overloaded.
◾
Heavy cutting line is used.
◾
The battery pack or the brush cutter is too
hot.
◾
The battery pack is disconnected from the
tool.
◾
The battery pack is depleted.
SOLUTION
◾
Attach the battery pack to the power
head.
◾
Remove battery, check contacts
and reinstall the battery pack until it
snaps into place.
◾
Charge the battery pack with EGO
chargers listed in this manual.
◾
Press down the lock-off lever and
hold it, then depress the trigger to
turn on the brush cutter.
◾
The motor will recover when the
load is removed. For continuous
working, decrease the load on the
power head.
◾
Use standard nylon cutting line with
diameter no more than 2.4mm.
◾
Allow the battery pack or the power
head to cool until the temperature
drops below 67°C.
◾
Re-install the battery pack.
◾
Charge the battery pack with EGO
chargers listed in this manual.
EN
17