Oase InScenio FM-Master EGC Instrucciones De Uso página 33

Ocultar thumbs Ver también para InScenio FM-Master EGC:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
Malfunction
The added EGC device is not
reacting to commands.
No connection between EGC
device and InScenio FM-
Master EGC.
LED is lit yellow
LED is flashing yellow slowly
(2 seconds on, 1 second off)
LED flashes red
The device does not start, the
LED flashes red
Possible cause
The EGC device has no power
supply
The data cable is interrupted.
The EGC device has no power
supply
The InScenio FM-Master EGC is
in the firmware update mode.
InScenio FM-Master EGC is
searching for a connection to
the router.
Internal error
No firmware found.
Remedy
Establish power supply
Check the EGC connections.
Establish power supply
Connect with the WLAN
„OASE_UPDATE_xxxxxx" or
„OASE_UPDATE_EGC_xxxxxx"
and use the app to start the
firmware update.
• Reduce the distance, do not
exceed the max. range of 80
m.
• Remove any sources of in-
terference that may be
weakening the WLAN signal
(e.g. other wireless devices,
differences in height).
• Switch on the WLAN router.
• Activate the WLAN function
on the router.
• If the router is no longer
available or defective, reset
the network settings of the
InScenio FM-Master EGC
and activate access point
mode
• Connect the InScenio FM-
Master EGC to another
router
• Disconnect the power sup-
ply, wait for 10 seconds,
then re-establish the power
supply
• Reset the InScenio FM-
Master EGC to the factory
default settings.
Contact the OASE service.
EN
33

Publicidad

Tabla de contenido
loading

Tabla de contenido