First Installation Of The Receiver - Fuba ODE8510 T2 STEALTH Manual Del Usuario

1.4 First installation of the receiver

Once the receiver has been connected (para. 1.2) and the adapter to the mains socket has been plugged in, the receiver
will automatically start up. If this does not happen, turn on the device using the appropriate button q on the remote
control. A simple wizard screen will then be displayed for the first installation.
NOTE
The installation wizard is presented not only at the first time installation, but also after a reset of the receiver (section
3.5.2).
Proceed according to the following guidelines:
Language
of the menu displayed on the screen (OSD-On Screen Display) with the arrow keys ◄ ►. Then
Language
Choose the
move to the next parameter by pressing the arrow button ▼.
Region
of installation using the arrow keys ◄ ► and continue with the arrow key ▼.
Set the Region
WARNING
Wrong Country setting may result in a partial or even a failure to identify and store channels.
Video Resolution
Set the video resolution of HDMI digital audio and video output with the arrow keys ◄ ►. Continue by pressing ▼.
NOTE
If the screen connected via HDMI displays problems, connect the receiver via SCART to set a compatible resolution value.
Aspect Mode
Choose the aspect ratio of the screen/TV connected to the receiver, either
formats will be presented on the screen:
16:9 Full
1. : For 16:9 screens. Images broadcasted in 4:3 will be adapted to the entire screen.
16:9 PillarBox:
2. For 16:9 screens. When images are broadcasted in 4:3, two black bars on the sides will be added so
that the original image is not distorted.
4:3
3. LetterBox: For 4:3 screens. When images are broadcasted in 16:9, the receive will apply two black bars above
and below to fill the screen without distorting the original image.
4. 4:3 PanScan: For 4:3 screens. When images are broadcasted in 16:9, they are adapted proportionally in hight of the
screen, cutting the side portions.
Continue by pressing the arrow ▼.
LCN
Logical channel sorting function (Logical Channel Numbering-LCN). If enabled, during channel scan, the receiver will
store the channels and automatically assigns to them a position in the list according to the numbering requested by each
broadcasters of these channels.
NOTE
In the event that two or more channels require the same number LCN, the receiver will autonomously assignment the
position of these conflicting channels in the channel list, which in any case be varied at a later date via the menu Edit
channel > TV/Radio Channel List (section 3.2.1)
Setting a Password
Define a four digit numerical password (PIN) for parental control (see also section 3.4.5). Enter the chosen PIN number
New Password
in the field with the numeric buttons on the remote control, then reinsert it in the
to confirm it. Continue by pression the arrow key ▼.
Channel Scan
Press the OK button and OK
channel search ends.
Channel viewing
Once the above steps are completed and therefore the Setup is complete, you can immediately take advantage of digital
terrestrial channels available.
NOTE

Some channels may not be visible because they subject to encryption or they are not compatible with this receiver.

During the life of the receiver, the canals could become obsolete or change the transmission parameters. We
recommend you update or reinstall the channel list on a regular basis (section 3.3).
that appears on the screen to begin the automatic channel scan and wait until the automatic
ODE8510 T2 STEALTH
16:9 4:3
or , and how images with different
Confirm Passord
field
5