Mitsubishi Electric PLK-E Serie Manual Básico página 143

M-228 [Message] PATTERN DATA DELETING TO MEMORY.....
M-229 [Message] PATTERN DATA READING TO MEMORY.....
M-230 [Message] PATTERN DATA DELETE FROM MEMORY ?
M-231 [Message] PATTERN DATA OVER WRITE TO MEMORY ?
M-232 [Message] MEMORY AREA OVER
M-233 [Message] MEMORY BROKEN
M-234 [Message] PATTERN DATA NOT DELETE (THIS PATTERN DATA IS USING)
M-235 [Message] MEMORY FORMAT OK ?
M-236 [Message] FD FORMAT OK ?
M-237 [Message] WRITING PROHIBITION IN THE INTERNAL MEMORY.
M-238 [Message] THERE IS THE SECOND HOME POSITION IN THE PATTERN DATA
M-239 [Message] THE AMOUNT OF THE HOME CORRECTION IS WRITTEN ON THE DATA
M-240 [Message] OUT OF AREA LIMIT
M-241 [Message] WRONG PATTERN DATA WAS SET
M-242 *.Read protect without home position.
[Message] NOT POSSIBLE TO READ EXCLUDING HOME POSITION
M-243 *.Write protect without home position.
[Message] NOT POSSIBLE TO WRITE EXCLUDING HOME POSITION
M-244 [Message] TOO MANY STITCHES
M-245 [Message] NOW CHECK SUM.....
M-246 [Message] INPUT FILE NAME
M-247 [Message] ILLEGAL SETTING PATTERN NO.
M-248 [Message] THE LIMIT OF THE SEWING AREA IS EXCEEDED
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] FORMER DATA IS DELETED WHEN OVERWRITING.
[Sub Message] DELETE THE NEEDLESS PATTERN DATA THEN RETRY
THE FUNCTION.
[Sub Message] THE MEMORY BREAKS. PLEASE INSTALL THE SYSTEM AGAIN.
[Sub Message] THE SELECTED SEWING DATA IS USED NOW.
[Sub Message] ALL THE SEWING DATA OF AN INTERNAL MEMORY IS DELETED.
[Sub Message] ALL THE SEWING DATA OF THE FLOPPY DISK IS DELETED.
[Sub Message] RELEASE THE INTERNAL MEMORY READ-ONLY SETTING
WHEN WRITING.
[Sub Message] PLEASE CHANGE THE PATTERN DATA
[Sub Message] WHEN >< IS SELECT,USUAL IS WRITTEN
[Sub Message] PLEASE CHANGE THE SEWING DATA.
[Sub Message] PLEASE CHANGE THE SEWING DATA.
*.Press the [RESET]key.
[Sub Message] PLEASE RETURN TO HOME POSITION
*.Press the [RESET]key.
[Sub Message] PLEASE RETURN TO HOME POSITION
[Sub Message] PLEASE CHANGE THE SEWING DATA.
[Sub Message] PLEASE WAIT FOR A WHILE
[Sub Message] PLEASE INPUT THE FILE NAME BY 8 CHARACTERS OR LESS
[Sub Message] PLEASE INPUT THE CORRECT SEWING DATA NUMBER.
[Sub Message] IT IS DANGEROUS. PLEASE CHANGE THE NEEDLEWORK DATA
140