Safety Instructions - Dynafit DAYMAKER Instrucciones De Uso

buckle closes with a loud click. The DYNAFIT logo should be
on the outside. To open: Slide both buckle ends away from one
another sideways.
Plug buckle: To close: Push both buckle ends one into another
so that they slot together. The plug buckle closes with a loud
click. To open: Press the buckle laterally.
Illustration 2 – Adjusting the chin strap: The chin strap should sit
at the sides of your head and is fastened with the buckle under
your chin. For a snug and comfortable fit, the strap length can
be adjusted under your chin. To position the strap properly at the
sides of your head, open the clips and adjust the strap length to
fit your head shape so that the strap sits below your ears on both
sides. The straps must not cover your ears. When the buckle is
closed, the chin strap should not apply any pressure on your
Adam's apple.
Illustration 4 – Check: When the chin strap is fastened and the
headband is flat to your head, ensure that the helmet is sitting
level horizontally and that it cannot slip forwards or backwards.
Illustration 3 – Attaching a headlamp: To attach a headlamp to
your helmet, slide the headlamp strap under the flexible clips on
the outer shell and position the lamp at the front of the helmet.
SAFETY INSTRUCTIONS: Always check the condition of
C
your helmet first before using it. Check all straps, attachment
parts and make sure that the adjustment elements on the head-
18
band function properly.
Make sure that the helmet shape is not deformed and that it
does not have any other visible damage.
WARNING: Please note that your helmet has been designed to
absorb the maximum amount of force during impact. This is
effected by the helmet deforming, which can cause it to incur
damage or be rendered unfit for use. However, this is not always
visible to the naked eye.
For this reason, the helmet must be replaced immediately fol-
lowing any significant impact in cases such as a climber fall or
as a result of rock or ice fall, even if the damage is not visible.
Extreme temperatures
+35°C/95°F), paint, solvents, adhesives/glues or stickers can all
alter the physical characteristics of the helmet, and therefore
may only be used with instructions or permission provided by
the manufacturer.
If you are in any doubt whatsoever regarding the condition of
your helmet, please contact your DYNAFIT specialist dealer.
LIFESPAN: The helmet's lifespan is very dependent on the
D
following factors: regularity of use, type of use, external influ-
ences, correct maintenance and cleaning method.
DYNAFIT explicitly recommends replacing any safety equipment
(PSA/PPE equipment) after a maximum of 10 years from the
date of production, regardless of whether the product has been
(below -20°C/-4°F and above