Safety Information; Safe Operation; Installation And Connection - Pontec PondoSolar 250 Plus Instrucciones De Uso

Safety information

This unit can be used by children from the age of 8 and by persons
with physical, sensory or mental impairments or lack of experience
and knowledge, as long as they are supervised or instructed on how
to use the unit safely and are able to understand the potential haz-
ards. Do not allow children to play with the unit. Do not allow children
to clean or maintain the unit without close supervision.

Safe operation

• Do not carry or pull the unit by its electrical cable.
• Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
• Only use original spare parts and accessories for the unit.
• In the case of electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the wa-
ter: Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the wa-
ter.
• Only operate the pump together with the supplied solar module and rechargeable battery house.
• Only charge the battery with the supplied solar module.
• Do not allow the pump to run dry.
• Protect the unit from knocks or vibration.
• Clean the unit at least twice a year.
• Keep the connection plugs dry.

Installation and connection

How to proceed:
B
1. Fit the nozzle extension, LED lighting and nozzle attachment together.
2. Fit the nozzle unit onto the pump.
3. Connect the connection cables of the LED lighting and the pump to the battery house.
– Push the plugs completely into the sockets (up to the stop) to ensure that the connection is watertight.
4. Connect the connection cables from the solar module and the battery house together.
– Push the plug completely into the socket (up to the stop) to ensure that the connection is watertight.
5. Assemble the ground stake set and attach it to the solar module.
– Ensure that the connection cable is routed downwards.
6. Fix the pump underwater to a smooth, clean surface using the suction cups.
7. Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
8. Install the battery house in an upright, elevated position to prevent the ingress of rainwater.
- EN -
11