Selecting A Fan Speed; Adjusting Vertical Airflow Direction - Mitsubishi Electric City Multi PKFY-P VAM-E Manual De Instrucciones

2. Operation
A
TEMP.
1
TIMER SET
˚C
TEMP.
TIMER SET
A B
˚C
TEMP.
TIMER SET
I PKFY Series
A
4
˚C
˚C
ON/OFF
FILTER
CHECK TEST
A
˚C
ON/OFF
FILTER
CHECK TEST
1
C D E
F
1Hr.
˚C
ON/OFF
FILTER
CHECK TEST
1
I PMFY Series
2.3. Selecting a temperature
s s s s s To decrease the room temperature:
1 Press
button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value decreases by
1 °C.
s s s s s To increase the room temperature:
1 Press
button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value increases by
1 °C.
• Available temperature ranges are as follows:
Cooling & Drying: 19 - 30 °C
Heating: 17 - 28 °C
Automatic: 19 - 28 °C
Circulation: — (Not available)
• The display flashes either 8 °C - 39 °C to inform you if the room tem-
perature is lower or higher than the displayed temperature.

2.4. Selecting a fan speed

1 Press
button to select a desired fan speed.
• Each time you press the button, available options change with the dis-
play A on the remote controller, as shown below.
Remote controller display
Fan speed
Low Medium 2
M
4-stage
The display and the fan speed of the unit will differ in the following situa-
tions:
• When STAND BY and DEFROST are displayed.
• Just after the heating mode (while waiting to change to another mode).
• When the temperature of the room is higher than the temperature set-
ting of the unit operating in the heating mode.
• In the dry operation, the indoor fan automatically turns to low-speed
operation. Switching of fan speed is impossible.

2.5. Adjusting vertical airflow direction

The vertical air vane helps select the vertical direction of the airflow.
1 Press
button to select the vertical airflow direction.
• Each time you press the button, the option changes are displayed on
the remote controller, as shown below.
A (Swing) → B → C → D → E → A
• If the room temperature is higher than the temperature set on the re-
mote controller while the unit is defrosting or preparing for heating, the
vertical air vane will move to the horizontal airflow position (B).
• In either cooling or dry mode, if you select C, D or E when the fan
speed is low, middle 2, a display reading "1Hr." F will appear.
After one hour, the air conditioner will switch automatically to horizontal
air mode B and the display "1Hr." F will disappear.
• When the heating thermostat is OFF, the louver automatically turns hori-
zontally during defrosting or preparation for heating.
Note:
PKFY-P·VAM has no swing display.
2.6. Adjusting the horizontal airflow direction
The airflow horizontal direction can be manually adjusted to the right or the
left.
Warning:
• Right/left adjustment should be made before starting operation.
• Never insert your fingers deep inside the air outlet as you could be
hurt by the rotating fan.
• Be sure to stand on a level surface.
I PKFY Series/PMFY Series
s s s s s To adjust, move the guide vanes to the desired direction.
A Guide vane
TEMP.
Medium 1 High