Information About The Device; Operating Instructions - Grasslin talis II PC 40-5-1i Manual De Instrucciones

Operating manual
talis II PC 40-5-1i – presence detector
Safety
Risk of fatal electric shock!
Only allow a qualified electrician to
install and connect the device.
WARNING!
• Before installing the product, disconnect the
mains voltage!
• Before installation, a type C circuit breaker
(250 VAC, 10 A) should be installed, in
accordance with EN60898-1.
• When lamps from some manufacturers burn
out, they can cause a high inrush current,
which can permanently damage the detector.
• Observe the national regulations and safety
conditions.
• Interventions in and modifications to the
device shall result in loss of warranty and
guarantee.
Read and observe this manual in order to ensure
trouble-free functioning of the device and safe
work.
For more information:
http://qrc.graesslin.de/801015297

Information about the device

Description of the device
The presence detector operates on the principle of
passive infra-red sensors (PIR sensor). It automat-
ically regulates the connected loads according to
whether persons are present (movement detection)
and according to the ambient brightness. The
built-in light sensor continuously measures the
strength of daylight and the system compares this
against the set lux value.
• The light remains switched on for as long
as movement and insufficient daylight are
detected.
• After the last movement is detected, the
lighting remains switched on for the set
run-on time.
• The lighting switches off automatically as
soon as sufficient ambient brightness is
reached, even if movement is detected during
this time.
• The presence detector is suitable for use in
indoor spaces.
Technical data
Supply voltage
Detection range
Range
Time setting
METER LUX
Light value
2000
300
Ambient temperature
100
Protection class
IP code
Energy consumption
230 V~ ±10% 50/60 Hz
360°
approx. 5 x 40 m (Fig. 6)
approx. 30 sec. – 30 min.;
TIME
; test
1s Test
approx. 10 lux – " ";
30m 5s
" " = learning mode
10
5m
-20 °C to +45 °C
15m
II
IP20
IP54 for on-wall mounting
< 1 W (in standby mode)
EN
7