Installing Dust Collection Hose; Mounting And Dismounting The Diamond Wheel; Cutting Procedures - Hitachi CM 5SB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING DUST COLLECTION HOSE

When cutting a material which generates cutting dust,
use the dust collection hose as follows:
(1) Remove the rubber cap and install the accessory
adapter. (Fig. 4)
(2) Install the dust collector hose for the power tool in
the accessory adapter. (Fig. 4)
CAUTION:
G
Always install a rubber cap on the dust collection
adapter when the dust collection hose is not used.
Dust collection
hose
Adapter
MOUNTING AND DISMOUNTING THE
DIAMOND WHEEL
CAUTION:
G
Be sure to disconnect the attachment plug from
the power receptacle to avoid serious trouble.
1.
Mounting the diamond wheel
(1) Remove the cover (A).
(2) Thoroughly remove dust accumulated on the
spindle and washers.
(3) As shown in Fig. 5. the concave portions of
wheel washer and wheel nut must be on the
diamond wheel side.
(4) Thoroughly clamp the wheel nut.
2.
Dismounting the diamond wheel
Use the provided wrench to remove the wheel nut.
(Fig. 5)
CAUTION:
G
A diamond wheel for mounting on this equipment
must have 7/8" (22.2mm) internal diameter. No
other sized diamond wheel should be used.
G
Always use the provided wrench to secure the
wheel nut.
Fig. 4
Switch
Side handle

CUTTING PROCEDURES

1.
Cutting procedures (Fig. 6)
(1) Place this tool on the material to be cut and align
the cutting line and the diamond wheel.
The cutting can be performed smoothly if you cut
straight ahead on the cutting line in the initial cut.
(2) Turn on the switch when the diamond wheel is
not touching the material to be cut.
Cutting line
2.
Precautions immediately after finishing operation
After switching off the machine, do not put it down
until the depressed center wheel has come to a
complete stop. Apart from avoiding serious
accidents, this precaution will reduce the amount
of dust and swarf sucked into the machine.
English
Push button
(Spindle lock)
Spindle
Screw
Dust
collection
cover
Wheel washer
Diamond
wheel
Wheel
nut
Wrench
Cover (A)
Fig. 5
Fig. 6
9

Publicidad

Tabla de contenido
loading

Tabla de contenido