Hardware Requirements And Precautions; Hardware Installation - Stardom DR5-WBS3 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21

3. Hardware Requirements and Precautions

1. Only one interface connection may be used at once per computer system.
2. The data formation of RAID 5 / RAID 3 uses four disks with space equal to the smallest disk of the
four; RAID 0 / Large is built of five disks; RAID 10 is built of two disks and used for its large storage
space; therefore, before using this system, it is recommended that each disk be installed before use
and that each disk be new and of the same brand and specification. Also, when you need to switch in
a new disk, it is recommended that you buy a new disk that is of the same brand and specification,
and same size as the old disk. If that is not possible, please choose a disk that is at least 20GB larger
than the other disk.
3. The actual storage capacity of DR5-WBS3 recognized by the system may differ from the total
capacity stated on the hard drives once the drives have been formatted.
4. When connected to the computer system, it's prohibited to remove, insert or swap the hard drive
while data transfer is being performed.
5. It's prohibited to change the positioning of the drives once the initial installation has been completed
as the changes made to the drive positions may destroy the RAID formation.
6. If you discover that hard drive failure is taking place, go to Section 6 "Replacement of Malfunctioning
Drive and Data Rebuild Instructions" and follow the steps accordingly.
7. Whenever turning off or unplugging the DR5-WBS3 from your computer system becomes necessary,
always remember to safely remove it from your operating system first.
8. RAID 5 / RAID 3 / RAID 10 / RAID 1 storage systems only allow one disk to malfunction at a time.
Therefore, when you find that two or more disks have malfunctioned, your data on those disks may
be damaged or lost; when you find that one or more disks have malfunctioned in RAID 0 / LARGE,
your data on those disks may be damaged or lost. It is recommended that you find a disk recovery
specialist in your area to attempt to recover your damaged or lost data.
9. It is highly recommended for users to back up important data contained within the DR5-WBS3 unit on
a regular basis or whenever the user feels necessary to a remote or a separate storage device.
Stardom will not be responsible for any lost of data caused during the use of the unit or the recovery
of the data lost.

4. Hardware Installation

Please follow the instructions below to complete the hardware installation.
Step 1 Open the package and take out the product making sure that all the enclosed contents are not
damaged or missing. Should you find damages or missing contents, please contact your supplier
immediately.
Step 2 If you want to install a DR5 system in the rackmount, please fasten the handle to the two panels of
the DR5. Then, use the screws from the component bag to screw the DR5 system to the slot
inside of the rackmount. Finally, make sure the DR5 is securely fastened.
Step 3 If you choose to place the system on a desktop, please fasten the foot pads to the bottom of the
system and place the system on a stable, level surface. Also, make sure that the heat sink fans
are not blocked and that the sides of the system have ample space to displace heat. (Please
select dry spaces and environments that are not harmful to the system.)
Step 4 Use the key included in the accessory kit and inserted into the key access opening to eject the
removable drive tray latch and extract the removable drive tray.
SOHORAID DR5 User Manual
5

Publicidad

Tabla de contenido
loading

Tabla de contenido