Replacement Of Malfunctioning Drive And Data Rebuild Instructions; System Temperature Overheat And Fan Failure Management; Visual Status Indicator Definitions - Stardom DR5-WBS3 Manual De Usuario

6. Replacement of Malfunctioning Drive and Data Rebuild Instructions

When a front hard drive indicator has lit up red and the audio alarm sounds, this could mean the indicated
hard drive may be malfunctioning. If this occurs, you may press the mute button at the rear of the system
to shut off the audio alarm and power off the system immediately if in the allowed operational state, and
then re-power on the system to double check and see if in fact the indicated hard drive has
malfunctioned. If the problem persists, please turn off the system and follow the directions below :
Step 1 Remove the drive tray containing the malfunctioned hard drive and disassemble the hard drive
from drive tray.
Step 2 Mount the new hard drive onto the tray and insert it back to the empty drive position of the DR5,
then push the latch into place making sure it is secured and locked.
Step 3 After swapping out for a new disk in RAID 5 / RAID 3 / RAID 10 / Clone and turning the power on,
you will see blinking red and blue lights on the new disk reader box which indicate that the data
on that disk is being rebuilt; At this time, you can use the DR5-WBS3 as normal; when the red
and blue indicators stop flashing, your data on the disk has been rebuilt.
Under RAID 0 / Large the failure of one disk will cause data corruption, so after replacing a disk,
please reformat the system disks.

7. System Temperature Overheat and Fan Failure Management

If the alarm indicator has lit up red and the audio alarm sounds, this could mean that either a system fan
has stopped operating entirely or the system temperature has exceeded over the default temperature of
60°C. When this occurs, you may press the mute button at the rear of the system to shut off the audio
alarm and power off the system immediately if in the allowed operational state to let the system cool.
Check and see if the overall operation environment is well ventilated and make sure there are no
blockages to the enclosed fan and then re-power on the system to continue use. If the problem persists,
please turn off the system and contact your supplier or the STARDOM tech support for further assistance.

8. Visual Status Indicator Definitions

States States
Power LED
Power on Blue
No disk Blue
Disk Fail Blue
RAID Fail Blue
Disk Idle Blue
Format Blue
Access Blue
Fan Fail Blue
Over Temp Blue
Rebuilding Blue
Front LED Front LED Front LED
Alarm LED
------
------
------
------
------
------
------
Red
Red
Source: Blue flash
------
Target: Blue and Purple light on alternatively
SOHORAID DR5 User Manual
HDD LED
Blue flash -> Blue
------
Red
Red
Blue
Blue flash
Blue flash
Blue
Blue
7
buzzer buzzer
1 long when
booting finished
------
------
4 short
------
------
------
4 short
4 short
------