FALMEC GRUPPO 3130 Manual De Instrucciones página 29

N
MOUNTING INSTRUCTIONS, RANGE HOODS
WITH BOX
GRUPPO INCASSO
Step 1
- Drill holes necessary for mounting.
- Insert the unit on the bottom of the wall unit. The springs (M) allow temporary hooking to the
wall unit panel (see fig. 1).
Step 2
- Open the panel (P) and tighten the screws (A) until the spring (M) holds against the wall unit
panel (see fig. 2). By tightening the screw (A), the spring (M) opens up and blocks the unit
against the panel. This is shown in figure.
Make sure that the unit is tightly fastened to the cabinet and then close the panel (P).
Step 3
- In the ventilation version, connect the output pipe connection of the motor to the external air
discharge hole.
- Only complete electrical connection after disconnecting the electrical power.
If removing the unit for extraordinary maintenance (carried out by qualified personnel): open
the panel (P) and loosen the screws (A), first on one side and then on the other, so that the
unit moves downward until it comes out of its seat. Support the unit to make sure that it does
not unhook suddenly.
GRUPPO INCASSO NRS
Phase 1
- Make the holes for the built-in.
- Remove carter C
- Insert the group at the bottom of the unit. Springs (M) allow the temporary hooking of the
group on the unit's panel (see fig. 1').
Phase 2
- Remove panel (P) as described in fig. H2, tighten screws (A) until spring (M) seals on the unit's
panel (see fig. 2'). As shown in the figure by tighten screw (A), spring (M) opens blocking
the group on the panel.
Ensure the group is securely fastened to the appliance.
- Remove metal filters (F) and assemble the NRS motor chamber (CM) on the group, securing
it with screws (V1). Connect connectors C1-C2, re-assemble carter C, as indicated in fig. 3'.
Phase 3
Fig. 4'
- In case of exhaust version, connect the output fitting of the fan to the external exhaust (F)
following the indications in the figure.
1) Measure the quota X as indicated in fig. 4' detail 1.
2) Cut the NRS pipe (A) according to the indication in fig. 4' detail 2.
3) Cut the NRS elbow (B) according to the indications in fig. 4' detail 3 so that the exhaust pipe
(A) is installed perfectly vertical.
Fig. 4''
1-2-3-4) Fasten the flange (FM) at the exhaust hole (F) with the 3 screws (V2).
Fig. 5'
1) Carefully insert the pipe (A) in the motor fitting (D);
2) Fasten the pipe (A) to the hood body with the 3 screws (V3).
27