Fusion EL Serie Instrucciones De Instalación página 4

Front View
15
176 mm (6 / in.)
16
A Sports model speaker is shown, but the dimensions are the
same for the Classic model.
Back View
15
176 mm (6 / in.)
16
1
156 mm (6 / in.)
8
Cleaning the Speakers
NOTE: When mounted correctly, these speakers are rated IP65
for protection in the harsh marine environment from the front of
the speaker. They are not designed to withstand high pressure
water spray, which may occur when you wash down your
vessel. Failure to carefully spray-clean the vessel may damage
the product and void the warranty.
Do not use harsh or solvent-based cleaners on the speakers.
Using such cleaners may damage the product and void the
warranty.
1
Clean all salt water and salt residue from the speaker grille
with a damp cloth soaked in fresh water.
2
Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
4
NOTICE
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the speakers
• Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.
The system lacks bass or high frequencies
• Verify that the correct wire polarity is observed between the
source and speakers.
The wires should be connected positive to positive and
negative to negative.
• Verify that the speakers are attached firmly to the mounting
surface.
The audio is distorted
• Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel
are not rattling.
• Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
The LED lights will not turn on
• Verify that all wiring connections are correct and tight.
Specifications
Max. power (Watts)
RMS power (Watts)
Efficiency (1 W/1 m)
Frequency response (+ 3 dB)
Min. mounting depth (clearance)
Mounting diameter (clearance)
Impedance
Amplifier power-rating
recommendation
LED supply voltage (sports model
speakers only)
LED load current at 16 Vdc (sports
model speakers only)
Optimum enclosure volume
recommendation*
Operating temperature range
Storage temperature range
Cone material
Water and dust rating
*Sealed enclosure, fully filled with absorption material.
NOTE: This speaker is not intended to be installed in a vented
or ported enclosure.
Compass-Safe Distances
All speakers contain magnets which may cause interference
with instruments on your boat. The size of the magnet used in
the speaker affects how much interference the speaker may
cause.
Interference can cause deviations and variations in the readings
of sensitive navigational equipment, such as magnetic
compasses. These deviations can cause inaccuracies or offsets
in the readings, but will not harm the equipment. To alleviate the
deviations, adjust the compass for the deviation following the
manufacturer's instructions or move the speaker away from the
80 W
20 W
84 dB
100 Hz to 15 kHz
11
43 mm (1 / in.)
16
1
130 mm (5 / in.)
8
4 ohm
From 20 to 40 W RMS, playing
music
From 10.8 to 16 Vdc
150 mA per color
3
8 L (0.3 ft. )
From 0 to 50°C (from 32 to
122°F)
From -20 to 70°C (from -4 to
158°F)
Polypropylene
IEC 60529 IP65
Installation Instructions