Getting Started - Wetrok Scuba Instrucciones De Manejo

Getting started
1. Unscrew the cap on 2. Remove filters
the top of the vacuum
unit
Wearing the backpack vacuum
7. Loosen the shoulder 8. Connect the waist
straps and the waist belt. strap
Lift the vacuum and slide
your arms through the
straps
BACKPACK ERGONOMICS
• The weight of the vacuum should be evenly distributed on your hips.
• Adjust the padded waist belt and shoulder straps for a custom fit.
• The backpacks have a ventilated backplate to keep the operator cool.
• The on/off switch is conveniently located on the waist belt of the backpack vacuums.
• Use the proper attachments for the job. Wetrok has attachments to perform most jobs without requiring you to bend over or get into difficult positions.
Operating the backpack vacuum
13. Do not tie extension 14. Fasten the ends of
cord and power cord the wands together,
together. Doing so will snapping them into place
result in damage to both
cords and will not be
covered under warranty
3. Check to make sure 4. Replace the Intercept
the Dome Filter did not Micro Filter and the
shift during shipping Micro Cloth Filter into the
vacuum
9. Tighten the waist belt. 10. Adjust the shoulder
It is very important that straps so that the unit
the weight of the unit fits comfortably, but the
be concentrated on your weight is still concentra-
hips rather than your ted on your hips
shoulders
15. Attach the floor tool to 16. Twist the wand onto
end of wand. the end of the hose
17
5. Replace the cap 6. Push the hose into the
cap opening
11. Connect the sternum 12. Slide the buckle up or
strap down the strap for best fit
17. Plug the power cord 18. The on/off switch
into the wall. Turn the is conveniently located
unit on, and proceed with on the waist belt of the
vacuuming. backpack vacuums
• EN