Maintenance; Engine Maintenance - Briggs & Stratton ELITE Serie Manual Del Operario

Ocultar thumbs Ver también para ELITE Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIFICATIONS & MAINTENANCE
SPECIFICATIONS
Starting Wattage . . . . . . . . . . . . . . . . . . . . 12,250 Watts
Wattage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7,000 Watts
AC Load Current
At 120 Volts . . . . . . . . . . . . . . . . . . . . . . . 58.3 Amps
At 240 Volts . . . . . . . . . . . . . . . . . . . . . . . 29.1 Amps
Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-phase
Rated Frequency . . . . . . . . . . . . . . . . . . . . . . . 60 Hertz
Fuel Tank Capacity . . . . . . . . . . . . . . . . . . . 7 U.S. gallons
Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . 230 lbs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The Owner/Operator is responsible for making sure that
all periodic maintenance tasks are completed on a timely
basis; that all discrepancies are corrected; and that the unit
is kept clean and properly stored. NEVER operate a
damaged or defective generator.
NOTE: If equipped with inflatable tires, keep the air pressure
at the value marked on the tire or within 15 and 40 psi.
NOTE: Should you have questions about replacing
components on your BSPP generator, please call
1-800-743-4115 for assistance.

Engine Maintenance

See engine operator's manual for instructions.
An oil drain tray is provided for your convenience to
change the oil and oil filter. Store tray in a convenient
location for periodic maintenance.
Changing Oil
1.
Place the half moon notch in the oil drain tray under
the oil drain plug (Figure 15).
Figure 15 — Changing Oil With Oil Drain Tray
drain tray notch
drain tray foot
2.
Place the oil drain tray foot tab in the slot on the base
of the generator, as shown.
3.
Follow the instructions given in the engine operator's
manual for draining oil.
4.
After oil has drained, reinstall the oil drain plug.
5.
Remove the oil drain tray from under the oil drain plug
and clean up any spilled oil.
Changing Oil Filter
1.
Place the half moon notch in the oil drain tray under
the oil filter (Figure 16).
Figure 16 — Changing Oil Filter With Oil Drain Tray
drain tray foot
2.
Place the oil drain tray foot tab in the slot on the base
of the generator, as shown.
3.
Follow the instructions given in the engine operator's
manual for changing oil filter and adding oil.
4.
Remove the oil drain tray from under the oil filter and
clean up any spilled oil.
CAUTION
Avoid prolonged or repeated skin contact with used
motor oil.
• Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
• Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
15
drain tray
notch

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Elite 01894-1

Tabla de contenido