Tools Needed; Door Removal, Leveling, And Alignment - Sears Kenmore 51759 Manual De Uso

Gather the required tools and parts and read all instructions before starting installation. Save these instructions for future reference.
NOTE: Before moving your product into your home, measure the doorway of your home to see whether you need to remove the
refrigerator and freezer doors. If door removal is necessary, see the instructions below.
IMPORTANT: Before you begin, unplug refrigerator or disconnect power. Remove food, the ice storage bin (on some models), and
any adjustable door or utility bins from doors.
TOOLS NEEDED: Bubble level; flat-blade screwdriver; 5/16" and 11/16" wrench; 1/4", 3/8", and 5/16" hex-head socket wrenches,
TORX T30 screwdriver.
® ®†
Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
6
Top Left Hinge
A
Do not remove A screws.
5
Wiring
A B
A. Wiring plugs
B. Wiring clip
C. Grommets
4
Water Dispenser
Tubing
A
A
A. Face of fitting.
3
Base Grille
A. Pull to the right for extraction.
B. Twist and pass underneath door.
†®TORX and T30 are registered trademarks of Acument Intellectual Properties, LLC.
2

Door Removal, Leveling, and Alignment

7 Door Removal
Full Refrigerator
1
C
Freezer
Water
door
filter door
Adjustable front wheels
2
Water Filter Door and
Base Grille
WARNING
Electrical Shock Hazard
8
Top Right Hinge
A
Do not remove A screws.
Cabinet
Refrigerator
Base
door
grille
Pull toward you.
9 Left and Right Bottom Hinge
Do not remove B screws.
10
Leveling screws
Lower
Raise
11 Locking Nut
Loosen
12
Alignment Screw
5/16"
Lower
wrench
Raise
Lower
11/16"
wrench
Tighten
Raise