Sears Kenmore 106.5178 Serie Manual De Uso Y Cuidado página 16

To Change a Light Bulb:
1. Unplug refrigerator or disconnect power.
2. Remove the light shield, as explained in the following
sections.
NOTE: To clean the light shield, wash it with warm water
and liquid detergent. Before reinstalling, thoroughly rinse
and dry the shield.
3. Replace the burned-out light bulb, as explained in the
following sections.
4. Reinstall the light shield, as explained in the following
sections.
5. Plug in refrigerator or reconnect power.
Refrigerator Compartment - Upper Lights
Light Shield Removal:
Slide the light shield toward the rear of the refrigerator and
remove it from the light housing.
Replacement Bulb:
If the burned-out light is a full-size LED bulb, replace it with
part number W10574850A (a 2.0 watt LED bulb).
If the burned-out light is an incandescent bulb, replace it
with an incandescent appliance bulb of the same size, shape
and wattage (40­watt maximum).
Light Shield Reinstallation:
Align the light shield in the grooves at the bottom edge of
the light housing, then slide it forward until it snaps into
place.
16
Refrigerator Compartment - Lower Lights
Light Shield Removal:
Slide the light shield to the right to remove the left end from
the wall slots, then pull the right end out of its wall slots.
Replacement Bulb:
If the burned-out light is a full-size LED bulb, replace it with
part number W10565137A (a 3.6 watt LED bulb).
If the burned-out light is an incandescent bulb, replace it
with an incandescent appliance bulb of the same size, shape
and wattage (40­watt maximum).
Light Shield Reinstallation:
Place the right end of the light shield into the wall slots, then
snap the left end into its wall slots.
Freezer Compartment - Upper Light
Light Shield Removal:
Gently squeeze the front and the bottom-rear edge of the
light shield to release the tabs from the wall slots, then pull
the light shield forward.
Replacement Bulb:
If the burned-out light is a full-size LED bulb, replace it with
part number W10565137A (a 3.6 watt LED bulb).
If the burned-out light is an incandescent bulb, replace it
with an incandescent appliance bulb of the same size, shape
and wattage (40­watt maximum).