Mounting The Camera And Transmitter - Dometic VT 50 WiF Instrucciones De Montaje

Mounting the camera and transmitter

No. in
fig. 2, page 3
3
4
5
6 Mounting the camera and transmitter
Tools required (fig. 3, page 4)
6.1
For installation and assembly you will need the following tools:
•
Drill head set (1)
•
Drill (2)
•
Screwdriver (3)
•
Set of ring or open-ended spanners (4)
•
Tape measure (5)
•
Hammer (6)
•
Centre punch (7)
To establish and test the electrical connection, the following tools are required:
•
Diode test lamp (8) or voltmeter (9)
•
Crimping tool (10)
•
Insulating tape (11)
•
Cable bushing sleeves (optional)
To secure the camera, transmitter and the cable, you may require additional screws, cable
binders and double-sided tape.
6.2 Preparing the camera for installation
Observe the following mounting instructions:
•
Place the camera in the centre over or under the number plate. The camera requires a free space
of 30 mm above or below the number plate.
•
Fasten the camera in a way that does not cover the number plate.
12
Meaning
Red cable (DC INPUT): Connection to the positive terminal (+) of the
power supply
Black cable (GND): Connection to the negative terminal (–) of the
power supply or earth terminal
Operating display; lights up as soon as voltage is applied
VT50WiFi
EN