Attaching The Transmitter; Connecting The Transmitter Electrically - Dometic VT 50 WiF Instrucciones De Montaje

Connecting the transmitter electrically

6.5

Attaching the transmitter

➤ Attach the transmitter temporarily to the planned installation location.
➤ Put the transmitter into operation.
➤ Activate the app on your receiving device (see chapter "Using VT50WiFi" on page 15).
If a fault occurs, e.g. there are flickering images:
➤ Adjust the location of the transmitter slightly.
➤ Retest the transmission.
If the camera image transmission is stable (no flickering images):
➤ Secure the transmitter with double-sided tape.
7 Connecting the transmitter electrically
7.1 General notes on laying cables
I
NOTE
•
As far as possible, use original ducts for laying the cables, or other suitable options
such as panelling edges, ventilation grilles or dummy plugs.
If no openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to emerge.
•
Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
•
Wherever possible, lay cables inside the vehicle, as they are better protected there than
outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
•
To prevent damage to the cables when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heaters,
etc.).
Use adhesive insulating tape to prevent water from penetrating the plug connection (fig. 7,
•
page 6).
When laying the cables (fig. 8, page 6), make sure:
•
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
•
Protect every through-hole made in the bodywork against water penetration, e.g. by using a
cable with a sealant and by spraying the cable and the cable sleeve with sealant.
14
VT50WiFi
EN