Skoda BKA 400 001A Manual De Instrucciones página 17

In case of communication loss of the remote control
the re-synchronising, based on the procedure given
in this manual, should be done.
Within the learning procedure of the new remote con-
trols or if the memory is necessary to be deleted, e.g.
the memory of the lost remote control, use "The
remote control code learning" procedure.
Resynchronisation
If it is necessary to carry out resynchronisation with se-
veral remote controls, the resynchronisation must be car-
ried out separately for each remote control.
- 4 -
- Insert the key in the ignition - position "0".
- Press both of the buttons on the remote control simulta-
neously (for about 12 seconds) - the blinking LED diode
will go out.
- Release the buttons - the LED will shine permanently.
- Turn the key in the ignition to position "I".
- Press any of the remote control buttons (three times in a
row for at least 1 second) - the blinkers will flash shortly
five times - this means that the control unit has carried
out the resynchronisation.
- Turn the key in the ignition back to position "0".
Check up the proper function of the remote control.
Teaching the remote control the code
The package is delivered from the manufacturer in a
"taught" state. It is only necessary to teach the remote
control the code, if the original remote control is lost, if
the number of remote controls is expanded or in the case
of a loss of communication between the remote control
and the control unit after a subsequent unsuccessful
resynchronisation.
- 5 -
- Insert the key in the ignition - position "0".
- Press both of the buttons on the remote control simulta-
neously (for about 12 seconds) - the blinking LED diode
will go out.
- Release the buttons - the LED will shine permanently.
- If you do not press any further buttons on the remote
control, the LED diode will go out (in about 80 seconds).
Carry out the following preparations for teaching all
the remote controls, which you wish to use.