Skoda BKA 400 001A Manual De Instrucciones página 18

- Remove the prescribed fuse.
- Replace the fuse after a minimum of 5 seconds;
- Turn the key in the ignition to position "I" within 5 se-
conds;
* Within 5 seconds, press any button on the remote con-
trol (three times in a row for at least 1 second) - the blin-
kers will flash shortly once - this means that the control
unit has taught the code to the remote control.
- The control unit is still in the teaching mode and you can
carry out the teaching of other remote control units star-
ting at instruction " * ".
- After having taught all the remote controls, turn the key
to position "0".
- After teaching the first remote control, all the previous
codes are deleted - this prevents the risk of the abuse of
any lost remote control unit.
Check the correct functioning of each remote control.
Attention
- Each time the vehicle battery is disconnected and con-
nected subsequently or if the prescribed fuse is removed
and reinstalled subsequently (see Fig. 5) the control unit
is switched over to the mode of "waiting" for turning the
ignition key to "I" position. You can cancel this mode
immediately by turning the key to "I" position and its sub-
sequent switching to "0" position.
- After turning the key to position "I" in the "waiting"
mode, the "teaching" mode is activated for 25 seconds.
- If the first remote control is not taught within this time or
if you turn the key to position "0", the "teaching" mode is
terminated and the taught codes remain as they were.
The remote control's batteries
The remote control uses the model CR2025 lithium
batteries or a standard equivalent model.
- A good condition of the battery - LED flashes for all the
time, for which the button is pressed.
- A low battery - a single LED flash. The battery should
be replaced.
Replace the battery as described below:
Attention. The spare batteries must conform to original
battery specification; otherwise, the remote control may
be damaged.