Setting Up The Galaxy System; Basic Setup; Stand Alone Test System Unit; Bench-Top Unit - MSA Galaxy Manual De Instrucciones

Chapter 2,

Setting up the Galaxy System

Basic Setup

The following basic steps are necessary to start testing with the Galaxy
System.

Stand Alone Test System Unit

Figure 2-1. Stand Alone Unit

Bench-top Unit

1. Place Test Stand on a flat, stable surface.
2. Make calibration gas connections as shown in FIGURE 2-1.
3. Plug the power supply into the the Test Stand power jack, which is
located on the bottom of the rear housing panel, toward the left-
hand side (when facing the Test Stand).
2-1