Troubleshooting - KUBOTA 54105 Manual Del Usuario

MAINTENANCE
1. Filter Cleaning: Your filter should be cleaned often to maintain peak Vac
performance. Allow the filter to dry before storing or picking up dry debris.
2. Cleaning a Dry Filter: Some removal of dry debris can be accomplished
without removing the filter from the Vac. For best cleaning results due to
accumulated dust, clean the filter in an open area. Clean the filter outdoors
and not in the living quarters. After filter removal from the Vac, remove the dry
debris by gently tapping the filter against the inside wall of the dust drum. The
debris will loosen and fall. For thorough cleaning of a dry filter with fine dust
(no debris), run water through it as described under "Cleaning a Wet Filter"
3. Cleaning a Wet Filter: After the filter is removed, run water through the
filter from a hose. Take care that water pressure from the hose is not strong
enough to damage the filter.
4. Filter Replacement: Allow the filter to dry before reinstalling and storing the
Vac or picking up dry debris.
CLEANING
1.To keep your Wet/Dry Vac looking its best, clean the outside with a cloth
dampened with warm water and mild soap.
2.To clean the drum: a.Dump debris out

TROUBLESHOOTING

WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK- UNPLUG
BEFORE TROUBLESHOOTING.
SYMPTOM
Vacuum will not operate
Dust comes out from
motor cover.
Reduced e ciency and
motor/speed vibration.
4 Gallon Wet & Dry Vacuum Cleaner
14
b.Wash the drum thoroughly with warm water and mild soap
c.Wipe out with a dry cloth
POSSIBLE CAUSES
No power supply.
Faulty power cord.
Container full.
The Reusable cloth lter is
missing or damaged.
There is a blockage in the
nozzle, hose, or the vacuum
inlets. Or the reusable cloth lter
is blocked by ne dust.
CORRECTIVE ACTION
Check power supply-cord,
breakers, fuses.
Unplug and check the power
cord. If damaged, have it
repaired by a professional.
Empty container.
Attach or replace the reusable
cloth lter.
Check nozzle, hose and inlets
for blockage. Take o the lter
and clean it. Or install new lter.
ENGLISH