Philips AVENT BPA-Free Manual De Usuario página 8

9977-iQUNO_USESFR_1030.qxd 30/6/08
Connecting the Electronics
Parts you will need for steps 5-8:
Assembled
Pump Body
(see pages 9-10)
Wall Plug Cord
5
11
16:49 Page 14
Control Handle
Battery Pack
Firmly push the control handle onto
the pump body so that it sits securely
on top of the silicone diaphragm.
Connecting the Electronics
For electric use connect the wall
6
plug cord to the control handle and
plug into an electrical wall outlet.
For battery use, open the top of
7
the battery pack and insert 4 x AA
batteries. (For compatible batteries,
see page 2.)
Connect the power cord to
the control handle.
HELPFUL TIP!
Batteries will last for approximately 6 hours.The light
on the control handle will display a continuous RED
pulsing flash to warn you when it is time to replace
them.There will be enough power for approximately
1 more pumping session, with no drop-off in
performance, before the pump switches itself off.
Need Help? Call us at 1.800.54.AVENT or visit www.philips.com/AVENT
i
12