HumanTechnik visuTone Instrucciones De Servicio página 8

4a. Selecting the type of signaling
Use the signal selector to choose whether
a doorbell or telephone ring is to be sig-
naled visually only, acoustically only or both
visually and acoustically. To do so, slide the
signal selector to one of the three following
settings:
- Selector at the top:
- Selector in the middle:
- Selector at the bottom:
4b. Selecting the melody
Use the melody selector to select one of the
four melodies available.
4c. Adjusting the volume
Use the volume control to adjust the volume
of the ring signal to one of five volume lev-
els.
4d. Adjusting the tone
Use the tone control to adjust the tone of the
ring signal to one of four levels between a
high-pitched and a low-pitched tone.
Note (special accessory)
A power cord available as a special acces-
sory can be plugged into the jack marked
"DC 6V" on the underside of the visuTone.
Maintenance and care
The unit does not require any maintenance.
If the unit does become dirty, simply wipe it
clean with a soft, damp cloth. Note: remove
the visuTone from mains socket!
Never use spirits, thinners or other organic
solvents. Do not set up the unit where it will
be exposed to full sunlight for long periods.
In addition, it must be protected against ex-
cessive heat, moisture and severe mechani-
cal shocks.
8 English
visually only
acoustically only
visually and
acoustically
Note: This product is not protected against
splash water. Do not place any container s
filled with water, such as flower vases, or
anything with an open flame, such as a lit
candle, on or near the product.
Please make sure that the batteries are not
exposed to excessive heat from such as
sunlight, fire or anything similar.
Warranty
The unit is a very reliable product. Should
a malfunction occur despite the unit having
been set up and operated correctly, please
contact your dealer or the manufacturer
directly. This warranty covers the repair of
the product and returning it to you free of
charge. It is essential that you send in the
product in its original packaging, so do not
throw the packaging away. The warranty
does not apply to damage caused by incor-
rect handling or attempts to repair the unit by
people not authorised to do so (destruction
of the seal on the unit). Repairs will only be
carried out under warranty if the completed
warranty card is returned accompanied by
a copy of the dealer's invoice/till receipt.
Always specify the product number in
any event.