Remote Control; Battery Replacement - GPO PR200 Manual Del Usuario

REMOTE CONTROL

1. Remove the battery cover from the back of the remote control.
2. Insert 2 AAA batteries. (Not included) Check the polarity (+ and -
symbols on the battery) and follow the instructions on the diagram
in the battery compartmentNOTE: Please make sure you properly
dispose of batteries (see your local regulations).
3. Replace the battery cover
4. User is advised to use Remote Control to operate most of the func-
tions for the main unit (amplifier)

BATTERY REPLACEMENT

If the battery is low, the distance with which the remote is operating will
be greatly reduced, and you will need to replace the battery.
1. To use the remote control, point it to the IR sensor (10) and press
the button gently but firmly. Since the remote control range is re-
duced when the unit is used in an angle, try to direct it to the remote
sensor
2. Do not expose the distance sensor to strong light (direct sunshine
or artificial light) and make sure there are no obstacles between the
remote sensor and the remote control
10
GPO PR200_user_Manual EU - Oct 2017.indd 10 26/10/2017 10:07