Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Guided Tour - AP1 Receiver
Samson AirLine
9: Output jack - Use this standard unbalanced high impedance
(5 - 10 K Ohm) 1/4" jack to connect the AP1 to your amplifier or
audio mixer. Wiring is as follows: tip hot, sleeve ground.
OUTPUT
10: DC input - Connect an optional 12 volt 200 mA power
adapter (available from your Samson dealer) here.
WARNING: Do not substitute any other kind of power adapter;
9
doing so can cause severe damage to the AP1 and will void your
warranty. Note that the AP1 can also be battery powered (see
#7 on the previous page and the "Setting Up and Using Your
AirLine System" section on page 12 in this manual).
11: Squelch control - This control determines the maximum
range of the AP1 before audio signal dropout. Although it can
be adjusted using the supplied plastic screwdriver, it should
normally be left at its factory setting. See the "Setting Up and
10
MIN
MAX
Using Your AirLine System" section on page 12 in this manual for
SQUELCH
more information.
11
DC INPUT
12 VDC
6
Publicidad
Tabla de contenido
