no risk of tripping, to prevent people from accidentally tripping over it or being injured. Also
make sure the cable is not under a carpet.
• The surface where the appliance is used must be stable, spacious (do not use on shelves), and
level (since the appliance could tip over or the liquid could spill out).
• Excessive humidity in the environment can cause the formation of condensation on windows
and furniture. In this case, turn the unit off.
• The appliance must be used at a temperature of between +10 to + 30°C.
• Make sure that the appliance works correctly: if not, turn it off and consult a qualified
professional.
• Make sure that the vapour outlet is clean and clear and not obstructed by objects, fabrics, or
other such materials to prevent overheating or the appliance from breaking.
• This appliance is not to be used with an external timer or with a separate distance control unit.
This is to prevent fire hazards should the appliance be covered or incorrectly positioned. Check
that other devices with high power consumption are not connected on the same circuit.
• If there is a fault or the appliance is not working correctly, switch it off and have it checked
by a qualified professional. Repairs done by an unqualified person can be dangerous and
cause the guarantee to become void.
Warning: fill the water tray only when the power is off and the adaptor plug is not inserted in
the plug point: always fill the water tray with tap water at room temperature, do not use hot,
distilled or purified water.
The appliance tray contains approximately 100ml of water and ensures running time of about
4↔6 hours.
OPERATION (see figures)
Warning: the perfume diffuser can be used only if fully and properly assembled, that is, with
the lid in the base, and placed on a perfectly horizontal surface.
Before each use, check that the appliance is in good condition, placed on a horizontal and stable
surface, and that the wiring is not damaged.
To use the appliance, proceed as follows:
1. Make sure the plug on the cable is connected to the base correctly, and that the adaptor is
NOT connected to the power outlet.
2. Remove the cover from the base (1), and with the measuring cup add demineralised water
(or tap water, if free of limestone) in the base tray, up to and not over the maximum level
(MAX, see figure), then and add a few drops of essential oil, fragrance, or citronella if you
wish to ward off pesky insects.
3. Without removing the base from the surface on which the appliance is being used, close the
cover (insert it on the base).
4. Plug the adaptor into the plug point: you will hear a "beep" and the appliance is now in
"stand-by" mode.
5. Press the "aroma" button to the diffuse the fragrance: the green LED lights up and the water
vapourises through the upper outlet in "min" mode and at regular intervals. By pressing the
button a second time, the diffuser changes to "max" mode and carries on working. By
pressing the button a third time, the vapour turns off: the unit is thus in "stand-by" mode.
13