Leckey KIT Seating System Instrucciones De Usuario página 9

7.1 Attaching the Seating
System to the Hi-low Chassis
Before attaching the seat unit to the base
raise the height of the chassis to its maximum
to reduce the risk of back strain.
Release the safety locking pin at the front of
the seat by pulling the pin (A) out and rotating
it through 90 degrees. Carefully tilt the seat
and place it onto the chassis, locating the
channel (B) at the rear of the seat over the
tube at the back of the chassis (C).
Pull the handle (D) at the front of the seat
unit up and then pivot the seat down.
Once the seat is fully lowered, release the
handle and push it forward to ensure it has
fully engaged on the front tube. Rotate the
safety locking pin (A) so that it engages in the
front of the handle.
D
A
Always check the handle and locking pin
are fully engaged before you place the user
in the seating system. If the handle is not
engaged properly, the seat unit can come
loose and could cause serious injury to the
user or the carer.
B
C
A