Briggs & Stratton ELITE Serie Manual Del Operario página 7

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
3. Slowly add fuel to fuel tank. Fill to red fuel level indicator
(see Figure 1). Be careful not to overfill tank.
Figure 1 - Add Fuel
Fuel Level Indicator
4. Replace fuel cap and wait for any spilled fuel to
evaporate.
CAUTION!
Some fuels, called oxygenated or reformulated
fuel, are fuels blended with alcohols or ethers. Excessive
amounts of these blends can damage the fuel system or cause
performance problems. If any undesirable operating
indications occur, use fuel with a lower percentage of alcohol
or ether.
Fresh fuel prevents gum from forming in the fuel system or
on essential carburetor parts. Purchase only quantities of fuel
that can be used within 30 days.
Install Pump Oil Breather Cap
1. Ensure compressor is resting on a flat, level surface.
2. Open Drain Valves (rotate fully counterclockwise) to
release residual air pressure build-up in air tanks
(see Figure 2).
Figure 2 Drain Valve
Drain Valve shown
in Open position
www.mymowerparts.com
CAUTION
Residual compressed air in pump can propel oil
and cause soft tissue damage to exposed skin or
eyes leading to severe injury.
• Always wear ANSI Z87.1 approved safety glasses with side
shields.
3. Remove and discard shipping cap.
4. Install pump oil breather cap into the oil fill
(see Figure 3).
Figure 3 - Install Pump Oil Breather Cap
CAUTION
Serious damage may result if operating the unit with
insufficient oil. Inspect oil level daily or with each use.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Wipe up any spilled oil.
6. Close Drain Valves (rotate fully clockwise) (see Figure 2
earlier).
ASSEMBLY
Oil Breather Cap
Oil Fill
Location
MAXIMUM
Oil Level
PROPER
Oil Level
Oil Drain Plug
7