Makita M3600 Manual De Instrucciones página 5

Stopper block
As the rotary stopper has three adjusting hex bolts, you
can easily obtain three different depths of cut without
readjusting the stopper pole. To adjust the hex bolts,
loosen the hex nuts on them and turn the hex bolts.
After obtaining the desired position, tighten the hex nuts
to secure the hex bolts.
1
2
3
Fig.3
► 1. Stopper pole 2. Chip deflector 3. Stopper
4. Adjusting hex bolt 5. Hex nut
Switch action
CAUTION:
Before plugging in the tool, always
check to see that the tool is switched off.
CAUTION:
Make sure that the shaft lock is
released before the switch is turned on.
To start the tool, move the switch lever to the I position.
To stop the tool, move the switch lever to the O position.
Fig.4
► 1. Switch lever
CAUTION:
Hold the tool firmly when turning
off the tool, to overcome the reaction.
ASSEMBLY
CAUTION:
switched off and unplugged before carrying out
any work on the tool.
Installing or removing the router bit
Insert the router bit all the way into the collet cone.
Press the shaft lock to keep the shaft stationary and
use the wrench to tighten the collet nut securely. When
using router bits with smaller shank diameter, first insert
the appropriate collet sleeve into the collet cone, then
install the router bit as illustrated.
To remove the router bit, follow the installation proce-
4 dure in reverse.
5
Fig.5
► 1. Shaft lock 2. Wrench
CAUTION:
Always use only the wrench provided with the
tool. A loose or overtightened router bit can be
dangerous.
CAUTION:
out inserting a router bit or install small shank
bits without using a collet sleeve. Either can lead
to breakage of the collet cone.
1
5 ENGLISH
Always be sure that the tool is
Install the router bit securely.
Do not tighten the collet nut with-
1
2