S&P SPLIT 2000 PTC Instrucciones De Uso página 12

The heater should not be placed immediately under a base of power

point.
The heater should be placed such that the powersupply is always

available.
The heater can be used as a fixed heater (mounted in a wall).

The heater cannot be connected to a programmer, timer or other de-

vice that controls the heater connection automatically.
Do not install the heater on a plastic wall.

Do not use this heater near a bath, shower or a swimming pool.

Do not use the product in rooms filled with explosive gases or vapours

generated by solvents and paints or that are inflammable.
Do not insert any rigid body through the grilles, this could damage the

heater, start a fire or electric shock.
Never leave your home with the product still running. If you do go out

make sure that the switch is off.
The minimum height of the installation is 1.8 metres, as shown in Fig

2.
The device has high surface temperatures, which must not be

touched, even after it has been switched off.
CAUTION: Some parts of this product may be become hot and cause

burns. Particular attention should be when children and vulnerable
people are present.
In order to avoid overheating, do not cover the heater.

This appliance can be used by children aged from 8 years and above

and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
12