Charging The Roscope I2000; Installing The Imager Head Cable - Rothenberger ROSCOPE i2000 Instrucciones De Uso

3.3

Charging the ROSCOPE i2000

Open silicon cover on handheld unit and insert External Power Supply into the mini USB socket
(Figure No. 4).
Figure No. 4 - USB Socket
NOTE: The ROSCOPE i2000 will only charge the battery if the temperature is between 0°C and
40°C (32°F and 113°F). Outside of this temperature range the ROSCOPE i2000 may continue to
operate but the batteries will not charge and the Charge Status LED will be off.
1. Make sure the charger is unplugged. Inspect the power cord, charger and battery for
damage or modifications, or broken, worn, missing, misaligned or binding parts. If any
problems are found, do not use charger until the parts have been repaired or replaced.
2. Clean any oil, grease or dirt from the equipment as described in the Maintenance section,
especially handles and controls. This helps prevent the equipment from slipping from your
grip and allows proper ventilation.
3. Check to see that all warning labels and decals on the ROSCOPE i2000 and A/C Power
Supply are intact and readable.
4. Select the appropriate location for the A/C Power Supply before use. Check work area for:
- Adequate lighting.
- Flammable liquids, vapors or dust that may ignite. If present, do not work in area until
sources have been identified and corrected. The charger is not explosion proof and can
cause sparks.
- Do not use the device in wet or damp areas.
5. With dry hands, plug the charger into the appropriate power source.
6. When the battery is fully charged, the LED indicator will change from red to green.
- Once the battery is charged, the ROSCOPE i2000 may remain plugged into the charger
until it is ready to be used. There is no risk of over-charging the battery. When the battery
has been fully charged, the charger automatically switches to retention charging.
NOTE: Internal Battery delivered with partial charge. It is recommended that the battery
be fully charged for at least 5 hours before initial use.
NOTE: Any service or replacement of the internal battery pack should be done by an
authorized ROTHENBERGER service facility.
3.4

Installing the Imager Head Cable

Only one imager should be connected to the unit at a time. Always make sure the unit is
off when installing or removing an imager.
To use the ROSCOPE i2000 inspection device, the imager head cable must be connected to the
handheld device. To connect the cable to the handheld device, make sure the key and slot (Figure
No. 6 ) are properly aligned. Once they are aligned, hand-tighten the knurled nut to hold the
connection in place. Note – The ROSCOPE i2000 is equipped with (2) different style connectors,
making backward compatible with a variety of ROTHENBERGER imagers.
ENGLISH 27