Troubleshooting - Van Berkel International RED LINE Serie Manual Del Usuario

AND RESPONSIBILITY
The manufacturer
machines with a limited war-
ranty of 24 months from the
purchasing date. The warranty
is extended only to defects that
arise under intended use condi-
tions and proper use. The war-
ranty does not cover defects
resulting from faults caused
by transport, purchaser's in-
competence or negligence, im-
proper installation or earthing,
unauthorised interventions,
natural wear and tear, voltage
variations greater than 10% of
the nominal value. Moreover,
the warranty does not cover
components intrinsically sub-
ject to wear, such as blades and
grinders, except in the event of
evident manufacturing defects.
The manufacturer declines any
direct and indirect responsibili-
ty coming from:
- failure to observe the instruc-
tions in this manual;
- use which does not conform
to prevailing specific regula-

Troubleshooting

PROBLEM
The machine does not start when
the on button is pressed
The machine starts when the on
button is pressed but the operation
indicator light does not turn on
Excessive resistance to cutting of
the product
The blade slows down or stops
while cutting the product
The machine does not stop when
the stop button is pressed
Excessive resistance in motion of
the sliding components (product
holder, carriage)
8
tions in the country of installa-
tion;
supplies - unauthorised
and/or repairs carried out on
the machine;
- use of non original accesso-
ries and replacement parts;
- exceptional events.
Transfer of ownership of the
machine automatically defaults
the manufacturer's liability for
the machine in question with
the exception of observance of
directive 2006/42/CE (liability
for any manufacturing defects
of the product).
The Identification tag on the
base-plate indicates manufac-
turer, machine, technical infor-
mation and CE marking.
DEMOLITION OF THE SLICER
The machines are comprised of:
- aluminum/magnesium alloy
structure;
- inserts and various compo-
nents and stainless steel;
- electrical parts and electrical
cables;
REASON
Lack of power or defective
control circuit
The indicator light may be
defective
The blade is dull
The drive belt may be
loose or damaged
The control circuit may be
defective
The lubrication of the
sliding guide may not be
sufficient
- electric motor;
- plastic material, etc.
modifications If dismantling and demolition
are entrusted to third parties,
use only companies authorized
for disposal of the above-men-
tioned materials.
The appliance complies with
the EU Directive 2012/19/
UE. Packaging materials and
appliances contain recyclable
materials. Your appliance con-
tains valuable materials that
can be recovered or can be
recyclable. Separation of the
remaining waste materials into
different types facilitates the
recycling of valuable raw mate-
rials. Leave the appliances at a
collection point. You can obtain
information on disposal from
your local authorities.
REMEDY
Check that the plug has been
correctly inserted. If the machine
still does not start, contact the
Service Center
Do not use the machine with the
indicator light off. Contact the
Service Center
Sharpen the blade
Contact the service center in
order to tension or replace the
belt
Immediately stop the machine,
removing the plug from the mains
outlet. Contact the service center
Carry out periodical lubrication as
described in this manual