Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
with switching colours
with fading colours
as a strobe light.
Note: Make sure to unplug any connection from the DMX input of the device if you want to use it in
stand-alone mode. A device in stand-alone mode may transmit DMX signals that could interfere with the
DMX signals from the controller.
Choosing a Predefined Static Colour
To choose one of the predefined colours:
1.
Press MENU.
2.
Press UP or DOWN until <CE--> is displayed and press ENTER.
3.
Use UP and DOWN to select a predefined colour (CE00–CE15) and press ENTER to confirm.
4.
Press MENU to quit.
Creating a Custom Static Colour
You can mix your own custom colour by adjusting the brightness of the red, green, and blue LEDs
separately in 16 steps. Proceed as follows:
1.
Press MENU.
2.
To adjust the brightness of the red LEDs, press UP or DOWN until <rL--> is displayed and press
ENTER.
3.
Use UP and DOWN to adjust the brightness from <rL00> (minimum) to <rL15> (maximum).
4.
Press ENTER to confirm.
5.
Press MENU to return to the menu.
6.
Repeat for the green <gL--> and blue <bL--> LEDs.
7.
Press MENU to quit.
Switching Colours
To use switching colours:
1.
Press MENU.
2.
Press UP or DOWN until <ASC> is displayed and press ENTER.
3.
Use UP and DOWN to set the switching speed from <AS00> (slow) to <AS15> (fast) and press
ENTER to confirm.
4.
Press MENU to quit.
Fading Colours
To use fading colours:
1.
Press MENU.
2.
Press UP or DOWN until <FAdE> is displayed and press ENTER.
3.
Use UP and DOWN to set the switching speed from <FA00> (slow) to <FA15> (fast) and press
ENTER to confirm.
4.
Press MENU to quit.
Strobe Light
To use the device as a strobe light:
1.
Press MENU.
2.
Press UP or DOWN until <FLAS> is displayed and press ENTER.
3.
Use UP and DOWN to set the strobe speed from <FL00> (slow) to <FL15> (fast) and press ENTER
to confirm.
4.
Press MENU to quit.
7.3
Master/Slave Mode
The master/slave mode allows for connecting several devices to a single master device in a daisy chain.
All slave devices will then work synchronously with the master device. The first device in the daisy chain
functions as the master device.
To set the devices to master/slave mode:
1.
Connect nothing to the DMX input [4] of the master device (the first device in the chain).
2.
Connect the DMX input of the first slave device to the DMX output of the master device.
V. 03 – 26/11/2014
VDPLP703RGB
6
©Velleman nv
Publicidad
Tabla de contenido
