Remote Control Unit - Denon AVR-1603 Instrucciones De Operación

11 REMOTE CONTROL UNIT

Operating DENON audio components
• Turn on the power of the different components before operating them.
1 Set mode switch 1 to "AUDIO".
2 Set mode switch 2 to the position for the
component to be operated. (CD, CDR/MD or
Tape deck)
3 Operate the audio component.
• For details, refer to the component's operating instructions.
While this remote control is compatible with a wide range of infrared controlled components, some
models of components may not be operated with this remote control.
1. CD player (CD) and CD recorder and MD
recorder (CDR/MD) system buttons
, : Manual search
6 7
(reverse and forward)
: Stop
2
: Play
1
, : Auto search (Cue)
8 9
3 : Pause
DISC : Switch discs
SKIP+ (for CD changers only)
3. Tuner system buttons
NOTE:
• TUNER can be operated when the switch is at "AUDIO" position.
3
1 2
3
2. Tape deck (TAPE) system buttons
: Rewind
6
: Fast-forward
7
: Stop
2
: Forward play
1
: Reverse play
0
A/B : Switch between decks A and B
SHIFT : Switch preset channel range
CHANNEL : Preset channel
+, – (up/down)
TUNING : Frequency
+, – (up/down)
BAND : Switch between the AM and FM bands
MODE : Switch between auto and mono
MEMORY : Preset memory
Preset memory
DENON and other makes of components can be operated by setting the preset memory.
This remote control unit can be used to operate components of other manufacturers without using the learning
function by registering the manufacturer of the component as shown on the List of Preset Codes (pages
192~194).
Operation is not possible for some models.
1 Set mode switch 1 to "AUDIO" or "VIDEO".
Set the AUDIO side for the CD, Tape deck or
CDR/MD position, to the VIDEO side for the
DVD/VDP, DBS/CABLE, VCR or TV position.
2 Set mode switch 2 to the component to be
registered.
3 Press the ON/SOURCE button and the OFF
button at the same time.
• Indicator flash.
4 Referring to the included List of Preset Codes, use the number buttons to input the
1 2 3
preset code (a 3-digit number) for the manufacturer of the component whose signals
4 5 6 you want to store in the memory.
7 8 9
0
5 To store the codes of another component in the memory, repeat steps 1 to 4.
NOTES:
• The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental
operation, cover the remote control unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function cannot be used for some models, even if
they are of makes listed on the included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset
codes to change the number and check.
• The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP
and DBS/CABLE.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR ..............................HITACHI
CD, TAPE ...........................DENON
CDR/MD.............................DENON (CDR)
DVD/VDP............................DENON (DVD)
DBS/CABLE........................ABC (CABLE)
ENGLISH
3
4
1 2
13