REDWALL V serie Instrucciones De Instalación página 3

Power wires should not exceed the following lengths.
SIP-500
WIRE SIZE
1V DC 14V DC 4V AC 1V DC 14V DC 4V AC
0. mm 480 640

(AWG) (1570) (100)
0.5 mm 760 1010

(AWG0) (490) (10)
0.8 mm 110 1610

(AWG18) (970) (580)
4
DETECTION AREA SETTING
You can adjust the detection area by 90 degrees in a horizontal
direction and by 10 degrees in a vertical direction.
Correct the vertical detection angle according to the mounting
height of the sensor unit.
Applicable SIP-5030
models
85°
Cautions>>
To rotate the main unit counterclockwise, loosen the
RHside adjustment screw. To rotate the main unit
clockwise, loosen the LH-side adjustment screw.
Otherwise, you may find it difficult to tighten or you may
find that you cannot tighten the adjustment screw when
you are securing the main unit.
To rotate the unit counterclockwise
4-1 Main Detection Area Setting
(1)
Adjust the angle of the main unit in a horizontal direction so
that you can cover the desired detection area.
1
Loosen the fixing
screw for the base.
SIP-100
170 410 550 180
(4490) (150) (1800) (400)
160 650 860 00
(7090) (10) (80) (660)
450 100 180 0
(110) (80) (450) (10560)
SIP-100
10°
10°
85°
Adjustment
screw
To rotate the unit clockwise
3
Rotate the main unit.
2
Loosen the adjustment screw.
4
Tighten the adjustment screw slightly.
()
Adjust the angle of the main unit in a vertical direction so
that you can cover the desired detection area.
m (ft.)
Cautions>>
If the mounting wall is at an angle, the arrow of the
main unit may exceed the top or bottom limit of "Angle
adjustment guide". Always check this using the area
viewfinder or the walk tester. If the detection area is too
high or too low, an object outside the detection area may
be detected or incorrect object detection may occur.
()
Remove the cover.
Cautions>>
The cover is linked to the main unit by nylon wire loop so
that the cover does not fall. Do not pull the cover using
excessive force.
(4)
Mount the area viewfinder.
1
-  -
Align the arrow of the main
unit with the "Angle adjustment
g u i d e " o f t h e a d j u s t m e n t
screw. The main unit is usually
adjusted within the width of this
guide.
When mounted at a height of
. meters (7.6ft.)
When mounted at a height of
4.0 meters (1ft.)
Hooks
3
Slide the cover downward
and release the hooks.
1
Loosen two fixing screws for
the cover and pull out the
cover until it stops.
Cover
2
Hold the heads of both cover fixing screws
with your hands, and pull down and remove
the bottom section of the cover from the
main unit.
Put the red string
round the main unit.
Red string to
hold the main unit
Center circle
of the lens
2
Insert and
mount to
3
Determine the
the main
detection direction
unit.
(see Step 5-
Area viewfinder AVF-1 (optional)
Inspection window
Area plate
(an accessory)
* Peel off the
protection
seal from
both faces
of the area
plate.
4
Insert the area
plate into the slot.
1
).