REDWALL V serie Instrucciones De Instalación página 8

7
MASKING THE FAR AREA SENSOR
Applicable SIP-5030
models
Cautions>>
• The window is linked to the main unit by nylon wire loop
so that the window does not fall. Do not pull the window
using excessive force.
• After you have masked the detection areas, mount the
window and place the excessive nylon wire loop inside
the main unit.
How to remove the window>>
Using the tweezers (an accessory), carefully attach the area
masking seals (an accessory) to the far area mirror.
Far area mirror
50 40 30 20 0
5 0 5
7
8

2
3
SIP-100
Window
Press the left bottom hole with your
finger, and pull the window up.
Area masking seals
MIRROR
0 0 20 30 40 50 [ft.]
0 5 0 5 [m]
0
9
6
5
4
8
MASKING THE NEAR AREA SENSOR
8- Masking the Detection Areas using
Masking Plates
Applicable
models
The near area mirror mounted in the main unit has 2 near
masking plates; one at the right side of this mirror and another
at the left side of this mirror. You can mask the detection area
by changing the position of these masking plates.
Cautions>>
You can mask the outside detection areas only; they are
areas  and 6. Use the area masking seals (an accessory)
to mask the other detection areas (see Step 8-2).
1
Remove the masking
plate from the storage,
and check the detection
area and the mirror you
use by referring to the
area chart.
Rib
6 4 6 4 2 2 5 5 3 1 3 1
Near area mirror
50 40 30 20
5 0

If tree branches or other moving objects
are in the path of the detection beam.
- 8 -
SIP-5030
2
Attach the masking plate to the mirror, and
secure it to the ribs.
3
Insert the fixing rubber form to secure
the knob of the masking plate.
0 0 0 20 30 40
5 0 5 0
6
2
5
3 4
SIP-100
Rib
50 [ft.]
5 [m]