Tabla de contenido
Publicidad
TROUBLE SHOOTING
• Trouble Shooting
• Unit Must be Level. If not level, TV will lean on one side and Operation
Speed will be irregular. Longevity of mount use will be greatly reduced from
not properly leveling the wall plate.
• Wall Screws and Mounting Location
• Wood Stud: Wall Mount Must have at least 4 Wall Point Location Mounted.
Any Wood Stud Installation Greater than 16" Wide Must use a
Dry Wall Anchor (Not Included) in the (B-Left) mounting Section
Refer to the Wall Template for additional Information.
-
• Spring Tension
• If the Tilt function is non-operational on your mount, check the depth of your
TV. If the depth is less then 6 cm it is considered a Slim TV, and the Spring
Tension screws must be removed (See page 15).
• Communication / IR / Power Cord
• The Power Cord must be installed last after you have already installed the
Communication IR cable or RS 232 (Not Included). Installation order should
be: IR Receiver or RS232 (Not Included) then Power Cord.
• Initial Setup
• User must set up the Right and Left Swivels Limits. User must setup the
Right side FIRST before setting up the Left Side.
Good
No Good
P34
Publicidad
Tabla de contenido
