Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GROUNDING AND AC POWER CORD CONNECTION INSTRUCTIONS
20.
The charger should be grounded to reduce the risk of electric shock. This charger is equipped with an electric cord having an equipment
grounding conductor and a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with
all local codes and ordinances.
DANGER.
Never alter the AC cord or plug provided - if it will not fit the
outlet, have a proper outlet installed by a qualified electrician. Improper
connection can result in a risk of an electric shock. This battery charger
is for use on a nominal 120-volt circuit, and has a grounding plug that
looks like the plug illustrated in FIGURE (A). A temporary adapter, which
looks like the adapter illustrated in FIGURE (C), may be used to connec
this plug to a two-pole receptacle, as shown in FIGURE (B), until a
properly grounded outlet can be installed by a qualified ele
DANGER:
Before using an adapter as illustrated, be certain that the center screw of the outlet plate is grounded. The green-colored rigid
ear or lug extending from the adapter must be connected to a properly grounded outlet - make certain it is grounded. If necessary, replace the
original outlet cover plate screw with a longer screw that will secure the adapter ear or lug to the outlet cover plate and make ground
connection to grounded outlet.
NOTE: USE OF AN ADAPTER IS NOT ALLOWED IN CANADA. IF A GROUNDING TYPE RECEPTACLE IS NOT AVAILABLE, DO NOT
USE THIS APPLIANCE UNTIL THE PROPER OUTLET IS INSTALLED BY A QUALIFIED ELECTRICIAN.
NOTE: SIDE TERMINAL TO BE USED IN POSITIVE CLAMP ONLY!
21.
refer to section 18f or 18g.
Storage position
Will not get lost. Always ready to
use.
LENGTH OF CHARGE
22.
a.
Test the battery for state of charge. Do not charge if it is over 75% charged or the battery is determined to be defective.
b.
Set beginning amps charge rate for size of battery and state of charge per charts
c.
Charge for length of time per charge,
d.
Discontinue charge when the specific gravity of electrolyte reaches 1.260 or above. A temperature compensating hydrometer should be
used for this reading. Discontinue charge if the battery begins to gas excessively or if the temperature of the electrolyte reaches
approximately 125°F. Do not overcharge batteries. Overcharging results in excessive water loss and eventual damage to the battery.
BATTERY SIZE
Ampere Hours
Reserve Capacity
Cold Cranking Amps
STATE OF CHARGE TABLE
STATE OF CHARGE
Specific Gravity
Open Circuit Voltage 6V
Open Circuit Voltage 12V
Open Circuit Voltage 24V
ctrician.
Extended position
Note: Pressure, when handle is squeezed,
holds adapter firm. Will not slip back.
BATTERY SIZE TABLE
SMALL
MEDIUM
LARGE
40
60
60
90
100+
275
350
400+
75%
50%
25%
1.225
1.185
1.140
6.2
6.05
5.95
12.4
12.1
11.9
24.8
24.2
23.8
GROUNDED
OUTLET
t
(A)
For instructions for NEGATIVE clamp attachment
CHARGE RATE Vs. MINUTES CHARGE
BATTERY SIZE %CHARGE
80+
0-25%
SMALL
25-50%
50-75%
0-25%
DEAD
MEDIUM
25-50%
1.110
50-75%
5.9
0-25%
11.8
LARGE
25-50%
23.6
50-75%
3
GROUNDING METHODS
ADAPTER
COVER OF GROUNDED
OUTLET BOX
GROUNDING
(B)
Thrust on terminal
Note: Clamp is released and spring
tension holds adapter firm.
MINUTES
15 30 45 60 75 90
45
30
30
25
25
20
30
20
20
15
15
10
A
M
15
10
10
10
5
5
P
70
50
45
40
35
30
E
R
45
30
25
20
20
20
E
25
15
15
10 10 10
S
90
55
55
50
45
45
60
40
35
30
30
30
30
20
20
15 15 15
ADAPTER
(C
)
MEANS
Publicidad
Tabla de contenido
