Zenoah RedMax PSZ2401 Manual De Instrucciones página 36

Sierra de mango
Tabla de contenido

Publicidad

OP6
36
English
8. Operation
NOTE
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
■ STOPPING ENGINE (OP4)
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the "Stop" position. (OP4)
IMPORTANT
• Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ CHECKING OIL SUPPLY
• After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown
in the figure. (OP6)
(1) Chain oil
NOTE
The oil reservoir has a capacity sufficient to provide
about 40 minutes of cutting time (when set to deliver
the minimum flow rate, or about as long as you'll get
from a tank of fuel). Be sure to refill the oil tank every
time when refueling the saw.
■ ADJUSTING OIL FLOW RATE
WARNING
Never fill the oil reservoir nor adjust the oiler with
the engine running.
IMPORTANT
An increase in bar oil flow rate will speed oil
consumption, requiring more frequent checks on the oil
reservoir. To ensure sufficient lubrication, It may be
necessary to check the oil level more frequently than at
fuel tank refills.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Redmax psz2401-ca

Tabla de contenido