Pioneer XW-NAS5 Manual De Instrucciones página 12

03 iPod playback
Important
If an error message lights in the front panel, try
following the points below:
Message What it means
There is a problem with the signal
path from the iPod to the unit.
Reconnect the iPod to the unit. If this
doesn't seem to work, try resetting
your iPod.
An unsupported device has been
connected.
was supported by this unit.
The iPod that is not supported is
connected. Check whether the iPod
was supported by this unit (page 9).
When the iPod software version is
too old, update the iPod software to
the latest version.
When there is no response from the
iPod, update the iPod software to the
latest version. If this doesn't seem to
work, try resetting your iPod.
If the iPod cannot be operated, check the
following items:
• Is the iPod connected correctly?
Reconnect the iPod to the unit.
• Is the iPod experiencing a hangup? Try
resetting the iPod, and reconnect it to the
unit.
12
En
Check whether the iPod
Tip
• iPod recharging occurs whenever an iPod
is connected to this unit. (This function is
supported in standby mode as well.)
• Whenever an iPod is connected to this
unit, turning the unit's power ON or
switching input to iPod will cause iPod
playback to begin automatically.
• When input is switched from iPod to
another function, the iPod playback stops
automatically.
• If the unit is set to standby when an iPod is
connected, the iPod's power will be turned
OFF automatically.