Setting The Pin Code; Pairing Bluetooth Adapter And Bluetooth Wireless Technology Device - Pioneer XW-NAS5 Manual De Instrucciones

04 Bluetooth® ADAPTER for Wireless Enjoyment of Music
1 Switch the unit into standby and connect
Bluetooth
ADAPTER to the ADAPTER PORT
located in the rear panel.
Press  STANDBY/ON.
2
3 Press INPUT to switch the unit to '
When pairing has not been performed,
' ' is displayed.

Setting the PIN code

Set this unit's PIN code to the same setting as
that for the Bluetooth wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
PRESET
SLEEP
1 Switch the unit into standby.
Press and hold  for three seconds.
2
The new PIN code will be displayed, indicating
that the PIN code has been changed.
Repeat step 2 until the PIN code is reset to the
value desired.
Note
1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT,
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
14
En
PRESET
ENTER
TUNE
BASS/
WAKE
TREBLE
UP
Pairing Bluetooth ADAPTER and
Bluetooth wireless technology
device
1
'.
"Pairing" must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
"Pairing" is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
see also the operating instructions of your
Bluetooth wireless technology device.
PRESET
SLEEP
1 When '
' ' will flash, and the unit will enter the
pairing standby mode.
2 Switch on the
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
Pairing begins.
3 Check to see that the
is detected by the
technology device.
lights when Bluetooth wireless
technology device is connected.
lights when Bluetooth wireless
technology device is not connected. In this
case, perform the connection operation from
the side of the Bluetooth wireless technology
device.
cannot be selected even if INPUT is pressed.
2
For more details,
PRESET
ENTER
TUNE
BASS/
WAKE
TREBLE
UP
' lights, press .
Bluetooth
wireless
Bluetooth
ADAPTER
Bluetooth wireless